The Legend of Heroes: Trails of Cold Steel [BLUS31572]

[ssshadow]

kd-11 is the graphics developer on RPCS3. A work in progress version that also runs this game can be downloaded here: https://mega.nz/#!aUIjFRKC!vLsG0iCjtT4X8...WQ3SXkZdaI

LLE module selection is automatic, simply don't select anything at all (with correct firmware installed, download ps3 firmware update 4.81 from Sony website and install it from tools --> install firmware)

[jazjaz36]

kd-11 is the graphics developer on RPCS3. A work in progress version that also runs this game can be downloaded here: https://mega.nz/#!aUIjFRKC!vLsG0iCjtT4X8...WQ3SXkZdaI

LLE module selection is automatic, simply don't select anything at all (with correct firmware installed, download ps3 firmware update 4.81 from Sony website and install it from tools --> install firmware)

I opened the kd-11 and installed the firmware but still I couldn't open the game. Log file is attached. Are there any more settings that I need?

[ssshadow]

Turn on "load required libraries"... I said it was automatic, but you turned it off.

[jazjaz36]

Turn on "load required libraries"... I said it was automatic, but you turned it off.

Same problem. RPCS3 just closes.

[27elrich21]

may config.yml is empty, i can run the game but only 15 fps, im tryin to edit the config but its empty

[jazjaz36]

may config.yml is empty, i can run the game but only 15 fps, im tryin to edit the config but its empty

how are you even able to run it? RPCS3 always closes for me.

[Jhon1234]

may config.yml is empty, i can run the game but only 15 fps, im tryin to edit the config but its empty

how are you even able to run it? RPCS3 always closes for me.

I'm getting 25 fps on
intel I7 4770
4600 hd

use ppu interpreter & opengl
After 1st run Install the game using rpcs3

I'm using firmware update that came with the game.

[jazjaz36]

may config.yml is empty, i can run the game but only 15 fps, im tryin to edit the config but its empty

how are you even able to run it? RPCS3 always closes for me.

I'm getting 25 fps on
intel I7 4770
4600 hd

use ppu interpreter & opengl
After 1st run Install the game using rpcs3

I'm using firmware update that came with the game.

25 fps is better than nothing. this is my graphics card. i have no idea if it even has a good capacity at all as i know squat about it
http://sta.sh/020qzlmbvjim

now the firmware you mean... is that firmware update 4.81 from sony? i did that too. ppu interpreter is the slowest right? tried that too. finally what do you mean by install the game?

as for rpcs3 version, i'm using the k-11 version that went with the game. "load required libraries" are checked. the game just closes on its own without even booting.

[ssshadow]

Turn on "load required libraries"... I said it was automatic, but you turned it off.

Same problem. RPCS3 just closes.

You didn't read the first post of the topic. Apply the LLVM bug workaround.

[Valdestroyer]

Hi, does dx 12 or vulkan works for this game ?
because it only showing gradient black white screen.
on opengl it runs almost perfect

my specs i7 4790K, 16 gb ram , gtx 1070