Flow [NPEA00021]

[Annie]

rpcs3-v0.0.0.6-454-gf66468f

CellFiber
CellPngDec
CellSail
CellSpurs
(If you enable CellSre it won't boot)

Log attached, won't get past a white screen after the last screenshot in the above post. It spits out cellSync errors in a loop.

Is cellPngDec required? I have redone it's HLE implementation, so I would be interested, if it works with the new implementation, if it didn't before.

rpcs3-v0.0.0.6-454-gf66468f

LLE:
cellFiber
cellSpursJq

Produces same output as above.
It was outputting

Code:

·! {PPU Thread[0x9f3] (snd_stream_service_thread)[0x00653e6c]} sys_tty: sys_tty_write(ch=0, buf=*0x20026df0, len=31, pwritelen=*0xd01d7340)
·W {PPU Thread[0x9f3] (snd_stream_service_thread)[0x007a6cc0]} cellFs: cellFsOpen(path=*0x21cb7820, flags=0, fd=*0xd01d7ce0, arg=*0x0, size=0x0) -> sys_fs_open()
·W {PPU Thread[0x9f3] (snd_stream_service_thread)[0x007a6cc0]} sys_fs: sys_fs_open(path=*0x21cb7820, flags=0, fd=*0xd01d7ce0, mode=0, arg=*0x0, size=0x0)
·W {PPU Thread[0x9f3] (snd_stream_service_thread)[0x007a6cc0]} sys_fs: *** path = ''
·E {PPU Thread[0x9f3] (snd_stream_service_thread)[0x007a6cc0]} sys_fs: [b]sys_fs_open('') failed: path is invalid[/b]

this in a loop (had to force shutdown rpcs3.exe process), the log was 400MB so I couldn't upload the log (it would be full of junk even if zipped), but I think it's pretty similar to the above one.