Experimental gamepad support in r2047

[Szarikow]

I have a Saitek PS1000 Dual Analog pad. If I set PSP analog to the left analog stick on the pad, jpcsp will not respond to it. However it will respond to horizontal axis of the right stick with that configuration.

[gid15]

I have a Saitek PS1000 Dual Analog pad. If I set PSP analog to the left analog stick on the pad, jpcsp will not respond to it. However it will respond to horizontal axis of the right stick with that configuration.

Could you post a log file at INFO level?

---

Reporting with r2050, it works perfectly now some buttons are detected with 9,10,11 instead of Button 9 ,Button 10 and so on but it works flawlessly.

64139 [SQEXTEC Movie AudioOutput] WARN controller - Unknown Controller Event on Rotación Z(rz): 0,190478
64139 [SQEXTEC Movie AudioOutput] WARN controller - Unknown Controller Event on Eje Z(z): 0,396811

These 2 are fixed in r2052.

[gid15]

Thanks gid15, gamepad support is wonderful. I have a suggestion to make the interaction even better: allow gamepads to be able to control save/load menus. (Up/down buttons to highlight the save and "X" to select and "O" to cancel.)

It could benefit keyboard users as well, but is especially useful to gamepad users who usually have their hands farther away from the mouse.

Thanks for the proposal! It is now implemented in r2055

[Szarikow]

Here is the INFO log and settings. I suspect the problems are caused by polish names of axis (which happen to contain polish characters). I could try to switch the pad to PS3 mode and use MotionJoy, but had some weird issues with another pad after using that software.

[Pelinor]

Thanks for the proposal! It is now implemented in r2055

That's excellent! I saw the post a few hours ago and was very eagerly waiting to get to my PC. It's great being able to sit back and play without having to use the mouse--other than start-up, of course.

[Szarikow]

Here is the INFO log and settings. I suspect the problems are caused by polish names of axis (which happen to contain polish characters). I could try to switch the pad to PS3 mode and use MotionJoy, but had some weird issues with another pad after using that software.

Ops, I forgot to actually attach the log file. Here it is.

[hyperspeedgx]

Triggers of XBOX 360 works or not?
On r2055 still don't work for me.

[gid15]

Triggers of XBOX 360 works or not?
On r2051 still don't work for me.
I'll try to r2055 and see what happens.

Please post a log file at INFO level and your Settings.properties.

[gid15]

Here is the INFO log and settings. I suspect the problems are caused by polish names of axis (which happen to contain polish characters). I could try to switch the pad to PS3 mode and use MotionJoy, but had some weird issues with another pad after using that software.

Could you test again on r2056? Redefine all your controls for your pad. Jpcsp is now avoiding to store the national name (polish names) in Settings.properties.

[Szarikow]

Could you test again on r2056? Redefine all your controls for your pad. Jpcsp is now avoiding to store the national name (polish names) in Settings.properties.

I just tested r2060. The pad works ok now. Thanks for your hard work